C2FUEL results at the “Workshop on the Conversion of CO2 to Fuels”

C2FUEL will present some of its results at the online “Workshop on the Conversion of CO2 to Fuels” organised by the European funded COZMOS (https://www.aspire2050.eu/cozmos) project on Monday 18 September 2023. The program is as follows: 13:00 – 13:05 Introduction 13:05 – 14:05 COZMOS  (Production of C3 fuels and chemical building blocks) 14:05 – 14:15

Read more

Evaluation of the relevant mass and heat transfer phenomena in a packed bed membrane reactor for the direct conversion of CO2 to dimethyl ether

A new paper published by Eindhoven University of Technology (TU/e) within the C2Fuel project! Evaluation of the relevant mass and heat transfer phenomena in a packed bed membrane reactor for the direct conversion of CO2 to dimethyl ether Serena Poto, Huub van den Bogaard, Fausto Gallucci , M. Fernanda Neira d’Angelo Fuel 350 (2023) 128783.

Read more

Carbon molecular sieve membranes for water separation in CO2 hydrogenation reactions: Effect of the carbonization temperature

Discover the last paper published by Eindhoven University of Technology (TU/e) and Tecnalia within the C2Fuel project! Carbon molecular sieve membranes for water separation in CO2 hydrogenation reactions: Effect of the carbonization temperature Serena Poto, A. Aguirre, F. Huigh, Margot Anabell Llosa-Tanco, David Alfredo Pacheco-Tanaka, Fausto Gallucci, M. Fernanda Neira d’Angelo Journal of Membrane Science,

Read more

Successful H2 production by HTES by ELCOGEN

The C2FUEL project has reached an important milestone as hydrogen was successfully produced at the nominal production rate (1 Nm3/h) by Elcogen with the high-temperature steam electrolysis system. Elcogen’s electrolyzers are based on solid oxide technology that enables substantial efficiency improvements compared to today’s state of the art technologies. Next tasks in the C2FUEL project

Read more

DK6 site preparation for final C2FUEL demonstrator

We are really happy to see DK6 site preparation, in Dunkirk, move forward with the installation of this utilities panel (March 2023)! It will allow us to feed the final C2FUEL demonstrator with compressed air, nitrogen and water for the conversion of CO2 into Dimethylether!

Read more

Steel-off gases pre-treatment unit design

The public deliverable linked to the Steel-off gases pre-treatment unit design is available on our website! Please download the document to know more on the design of the Blast Furnace Gas pretreatment system located upstream the carbon capture and conditioning unit, where CO2 is removed by absorption with an amine based solvent and sent to

Read more

1000 hours of CO2 capture and regeneration from blast furnace gas achieved!

C2FUEL is happy to announce, after minor technical difficulties and a global pandemic, that the first 1000-hour degradation campaign of a CO2 capture solvent (30wt% MEA) with industrial blast-furnace gas has been achieved. The demonstration – using a minipilot conceived by ENGIE Lab CRIGEN and CNRS-LRGP – was conducted on the DK6 site in Dunkirk,

Read more

C2Fuel results at the NCCC conference

The 23rd Netherlands’ Catalysis and Chemistry Conference will take place on 9-11 May 2022 at the Conference Centre Leeuwenhorst in Noordwijkerhout (The Netherlands). Latest C2Fuel results will be presented: 2 posters: “Morphology study of bismuth nanoparticles as catalyst for electrochemical CO2 reduction to formate”. Alex J.W. Man, Tim Wissink, Marta C. Figueiredo, Emiel J.M. Hensen

Read more

C2FUEL gets closer to CO2 value Europe

To increase its visibility and disseminate its results even more widely and efficiently, C2FUEL will rely on the communication capabilities of CO2 Value Europe throughout Europe and beyond. CO2 value Europe is the non-profit association representing the Carbon Capture and Utilisation (CCU) community in Europe. It aims at promoting the development and market deployment of

Read more